The home battery rebate in 2026: the short answer
The federal Cheaper Home Batteries Program takes around 30 per cent off the upfront cost of an eligible home battery, between 5 kWh and 100 kWh, connected to new or existing solar. The government funds it, it comes off your installer's invoice (or as a rebate after installation), and you don't apply for it yourself.
What changed in 2026 is the pace at which it shrinks.
On 13 December 2025 the government announced it was expanding the program from an original estimate of $2.3 billion to around $7.2 billion over four years. The amended regulations were finalised on 5 February 2026, and two changes took effect on 1 May 2026:
• The figure that sets the size of your discount — the STC Factor — now drops every six months instead of once a year, and by more each time. • The discount now tapers with battery size, so the first 14 kWh earns the full rate and every kWh after that earns less.
And one line on the Department of Climate Change, Energy, the Environment and Water's program page decides the whole question for anyone building a new home: 'The discount that you are entitled to is determined by the STC Factor on the date the battery is installed.'
Not the date you sign the building contract. The date it's installed. On a new build, that's near the end of the job.

How the battery discount is calculated
The discount runs through the same scheme that has subsidised rooftop solar for years — the Small-scale Renewable Energy Scheme. Your battery creates small-scale technology certificates (STCs), and the government buys the certificates created for batteries to fund the discount.
The maths is simple once you see it:
Usable battery capacity (kWh) × STC Factor = number of certificates
with the taper applied by size:
• 0 to 14 kWh (inclusive): STC Factor applied at 100% • Over 14 kWh, up to 28 kWh: STC Factor applied at 60% • Over 28 kWh, up to 50 kWh: STC Factor applied at 15%
Each certificate is worth up to $40 — that's the clearing house price — and through 2026 most traded just under that, around $38 to $40. Your installer will tell you the value they're applying.
Note 'usable' capacity. A battery's usable capacity is usually a little below its headline figure, and it's the usable number that counts. If you want the exact count for a specific product, the Clean Energy Regulator's REC Registry has an STC calculator, and any accredited installer can run it for you.
The STC Factor schedule to 2030
This is the table that matters. It's set out in the amended regulations and published by the department:
• 2026, January to April: 8.4 • 2026, May to December: 6.8 • 2027, January to June: 5.7 • 2027, July to December: 5.2 • 2028, January to June: 4.6 • 2028, July to December: 4.1 • 2029, January to June: 3.6 • 2029, July to December: 3.1 • 2030, January to June: 2.6 • 2030, July to December: 2.1
Read it as a countdown. A battery installed in December 2026 attracts a factor of 6.8. The same battery installed in July 2027 attracts 5.2 — almost a quarter less, for exactly the same product.
The government's reasoning is that battery prices are falling, so the discount falls with them to keep it at roughly 30 per cent. That's the policy aim. Whether the price you're quoted actually falls as fast as the discount does is a different question, and not one anybody can promise you.
What the rebate is worth: worked examples
Estimates only — they use the official factors and a certificate value of $38 to $40, and your installer's figure will depend on the exact usable capacity and the certificate price on the day.
A 13.5 kWh battery (a common size for a family home). All of it sits under the 14 kWh threshold, so it earns the full factor:
• Installed May to December 2026 (6.8): about 92 certificates, roughly $3,500 to $3,650 • Installed January to June 2027 (5.7): about 77 certificates, roughly $2,900 to $3,050 • Installed July to December 2027 (5.2): about 70 certificates, roughly $2,650 to $2,800 • Installed January to June 2028 (4.6): about 62 certificates, roughly $2,350 to $2,500
A 20 kWh battery. The first 14 kWh earns the full factor and the next 6 kWh earns 60 per cent of it, so it counts as roughly 17.6 kWh:
• Installed May to December 2026 (6.8): about 120 certificates, roughly $4,550 to $4,800 • Installed July to December 2027 (5.2): about 92 certificates, roughly $3,450 to $3,650
Two things jump out.
The drop between 'installed this year' and 'installed late next year' is around $850 to $1,100 on a typical home battery. Not life-changing on a build budget. But it isn't nothing, and it's money people tend to assume they've locked in when they haven't.
And the taper changes the sizing conversation. Past 14 kWh, each extra kWh earns 60 per cent of the rebate; past 28 kWh, only 15 per cent. Bigger batteries still get help — just proportionally less.
Got questions about your project?
Free 30-min consultation with Oliver — bring your block, your brief, your budget. No sales pitch, just honest advice.
Why this hits new builds harder than retrofits
If you already live in your house, you choose your install date. You can sign on Monday and have a battery on the wall in a few weeks.
On a new build, the battery is one of the last things installed. It goes on after the electrical fit-off, close to practical completion. A home with a contract signed in November 2026 and a typical build time in Western Sydney isn't getting its battery installed in 2026. Depending on approvals and the build programme, it's more likely to land somewhere in the second half of 2027 — at a factor of 5.2, not the 6.8 everyone quotes today.
So when a new-home quote shows a battery 'after rebate', ask one question: what install date and what STC Factor is that figure based on?
If the number was worked out on today's factor and the battery won't go in for another nine or twelve months, the 'after rebate' price is optimistic. Depending on how your contract is written, either you or your builder is carrying that gap. Better to know which before you sign than at handover.
It's also worth knowing who receives the discount. Normally you assign the right to create the certificates to your installer, and the installer takes it off the price. You can claim them yourself through the REC Registry instead, but you can't do both.
Install now, or build battery-ready and add it later?
This is the real decision, and there isn't one right answer.
Install it with the build. The battery is commissioned with the rest of the electrical work, the system is designed as one, and you get the factor in force at install — which, on a new build, is usually a step or two below today's. You also get the benefit from the day you move in.
Build battery-ready and add it later. The house gets everything the battery needs except the battery: a suitable location, conduit, switchboard capacity, a battery-compatible inverter, a data connection. You add the battery when it suits you. The catch is that the factor keeps falling every six months to the end of 2030, so waiting buys you a lower discount — offset, if the government's assumption holds, by lower battery prices.
What I'd steer people away from is the middle option: no battery and no provision. Retrofitting the conduit and switchboard work into a finished, plastered house costs real money that could have been almost nothing during the build.
If you're weighing up the whole energy package — solar size, battery, EV charging — the costs and payback are covered in solar, battery and EV charger setup for a new Sydney home. This post is about the timing of the discount. That one is about whether the system pays for itself.
What 'battery-ready' should actually mean in a new home
If you're going battery-ready, make it real rather than a line in the inclusions. Here's what I'd want on the plans:
• A planned battery location. Battery installations have their own Australian Standard (AS/NZS 5139), and there are rules about where a battery can go relative to habitable rooms, exits and other hazards. A garage wall or a protected external wall is common. Pick it during design, not after. • Shade and ventilation. Batteries don't like baking on a west-facing wall through a Western Sydney summer. Location affects performance and life. • Conduit from the switchboard and inverter to that location, installed before the walls are lined. • Switchboard space for the protection devices a battery needs. • An inverter that will take a battery, or a clear plan to replace it — ask the question, don't assume. • A reliable data connection at the battery location, because the next point needs it.
None of this is expensive while the frame is open. All of it is annoying once it isn't.
Free initial conversation
Get a real number for your block
Two minutes now saves the guesswork. Oliver will respond within 4 working hours for a free initial conversation about your block, your brief and what it could cost to build.
- Read against your block, not a brochure: zoning, slope and council controls first
- NSW contractor licence 487805C
- Oliver will respond within 4 working hours. No sales pressure.
The NSW layer: what's left on top of the federal discount
NSW used to offer its own upfront battery incentive for households under the Peak Demand Reduction Scheme. When the federal program started, the state's upfront incentive stopped for ordinary households, so for most Western Sydney homeowners the federal discount is now the main upfront help.
NSW does still run an incentive for connecting a battery to a virtual power plant (VPP) — an arrangement where an energy company can draw on your battery at peak times in exchange for payments or credits. The rules and amounts have changed more than once, so check the current figure with the NSW Government's energy website before you count on it. Make sure any VPP agreement suits how you actually use power. You're giving someone else partial control of a device you paid for.
The federal department says people may be eligible under more than one scheme, and it points to the Household Energy Upgrades Fund for discounted finance on home energy upgrades. Ask your lender if that's relevant to your build loan.

Checks before you sign for a battery
Whether the battery is in your building contract or bought separately later, the department's own checklist is sound, and I'd add one item.
• The battery is on the Clean Energy Council's approved list. • The installer is accredited with Solar Accreditation Australia — you can check online. • The installer is on site for set-up, installation and commissioning. • The quote states the discount and when you'll get it — upfront off the invoice, or after installation. • The quote states the system warranty and the expected payback period. • And mine: the quote states the install date or period the discount was calculated on. On a new build, that's the one that decides whether the number holds.
Bigger isn't automatically better either. The department makes the point itself: a battery too large for your solar or your inverter can limit the benefit. Size it to your actual evening use, not the brochure.
If you're planning a new home and want the energy package priced honestly against your timeline, get in touch. And if you're still at the 'what will this block let me build' stage, start with a land and feasibility assessment.



